Business Aviation

Staff
LYCOMING and CONTINENTAL MOTORS Lycoming TIO-540-AK1A, and Continental TSIO-360-MB, TSIO-360-SB, and TSIO-360-RB reciprocating engines [Docket No. FAA-2012-1245; Directorate Identifier 2012-NE-41-AD; Amendment 39-17626; AD 2013-21-02] – supersedes an existing AD affects engines with AD certain Hartzell Engine Technologies (HET) turbochargers (Model TA0411). The original AD required removing certain HET turbochargers from service before further flight. This AD also requires removing certain HET turbochargers from service before further flight.
Business Aviation

Click here to view the pdf
Business Aviation

Staff
AGUSTAWESTLAND Model A109A, A109A II, A109C, A109E, A109K2, A109S, AW109SP, A119, and AW119 MKII helicopters [Docket No. FAA-2013-0881; Directorate Identifier 2013-SW-056-AD; Amendment 39-17628; AD 2013-20-51] – publishes an emergency AD sent previously to all known U.S. owners and operators of these helicopters that requires, before further flight, inspecting certain Thomas coupling nuts on the tail rotor drive shaft line for a crack and replacing all the nuts if any nut is cracked. This AD also requires replacing all affected Thomas coupling nuts within 10 hr.
Business Aviation

Staff
Bombardier has undertaken initiatives to increase certain maintenance intervals for Learjet 40/45 and newer Challenger and Global aircraft. The manufacturer says the intervals for hourly task and monthly checks are improving by as much as 50%, lowering direct maintenance costs and reducing aircraft downtime. Bombardier estimates the changes could reduce labor costs by nearly 50% while improving dispatch availability by 250 days over the lifetime of an aircraft, depending on the model.
Business Aviation

Staff
PRATT & WHITNEY CANADA PT6A-114 and -114A turboprop engines [Docket No. FAA-2013-0766; Directorate Identifier 2013-NE-26-AD] – proposes to require initial and repetitive borescope inspections of compressor turbine (CT) blades, and the removal from service of blades that fail inspection. This proposed AD was prompted by several incidents of CT blade failure, including two fatalities, resulting in power loss and inflight shutdown of the engine. FAA estimates that the proposal affects 300 engines installed on U.S.-registered aircraft at a cost of $102,000 for the fleet.
Business Aviation

Staff
BOMBARDIER Model CL-215-6B11 (CL-415 Variant) airplanes [Docket No. FAA-2013-0833; Directorate Identifier 2012-NM-140-AD; Amendment 39-17615; AD 2013-20-09] – requires replacing the panel assembly of the main distribution center (MDC) rack. This AD was prompted by findings of chafed power wires due to flexing of the MDC rack panel. FAA is issuing this AD to prevent damage to power wires, which could cause simultaneous loss of systems such as electrical power, pilot indications, and caution/advisory lighting systems, which are essential for safe flight.
Business Aviation

Kerry Lynch
The National Business Aviation Association, continuing its effort to raise the visibility and underscore the importance of business aviation, is highlighting the key role the industry plays in global marketplaces with a new study that finds most top global companies rely on business aircraft.

Staff
Dallas Aeronautical Services (DAS) broke ground on a new 50,000-sq.-ft. facility in Cedar Hill, Texas that will enable the company to consolidate operations currently spread among five separate buildings. Completion of the new facility is slated for early 2014. The facility will accommodate DAS’s aircraft component work and include two autoclaves, custom paint center and a range of testing facilities. In addition, the company’s Brazil operation is expanding into a new facility in Sao Jose do Campos, Brazil in the first half of 2014.
Business Aviation

Kerry Lynch
Business jet billings are surging ahead on the strength of large-cabin business jet deliveries, but ongoing delivery woes at the light end of the market continue to temper overall business jet shipments. Industry billings for the first nine months have reached $15.4 billion, nearly one-quarter more than the $12.4 billion in billings a year ago, according to the latest report from the General Aviation Manufacturers Association. This is despite a 2.1% decline in business jet shipments from a year ago.
Business Aviation

Staff
Beechcraft received a follow-on order from the Mexican air force (FAM) for six T-6C+ military trainers. The order doubles the original order for six T-6C+ aircraft that FAM placed in January 2012. The order calls for the trainers to be delivered later this year after the necessary export licenses are obtained. The trainers will replace FAM’s aging PC-7 fleet.
Business Aviation

Staff
EUROCOPTER FRANCE Model AS332C, AS332L, AS332L1, AS332L2, EC225LP, and SA330J helicopters [Docket No. FAA-2013-0872; Directorate Identifier 2013-SW-012-AD] – proposes to require inspecting the turnbuckles for corrosion or a crack, and depending on the results, either replacing the turnbuckle or treating the turnbuckle for corrosion. This proposed AD is prompted by a report that a turnbuckle had failed because of corrosion.
Business Aviation

Kerry Lynch
Eyeing difficult budget negotiations and the prospect of more sequestration cuts, a dozen aviation organizations are urging lawmakers to ensure that the contract tower program receives adequate funding and is shielded from potential dismantling. The organizations, representing airports, local communities, business aviation, airlines and other interests, wrote the House and Senate Appropriations Committees endorsing language that dedicates $140 million in funding to the contract tower program.
Business Aviation

Staff
The city of McKinney, Texas, took over operations, including a new city-run fixed-base operation, at Collins County Regional Airport. McKinney Air Center will provide fuel, ground services and a range of amenities for aircraft at the airport and will be headed by Mark Jaraczewki, who brings 20 years of experience as an FBO general manager. McKinney says the move is designed to spur economic development.
Business Aviation

Kerry Lynch
Embraer is planning to more than double its footprint in Melbourne, Fla., as it expands its business jet operations there to include assembly of its new Legacy 500 and 450 business jets.
Business Aviation

By Jen DiMascio
A Senate panel on aviation led by Sen. Maria Cantwell (D-Wash.) convenes this week to discuss how to keep aviation manufacturing in the U.S. competitive. But competition in the increasingly global airline and aerospace industries is in the eye of the beholder. U.S. unionized pilots and flight attendants are scrutinizing how Norwegian Air Shuttle proceeds with its latest round of contract negotiations. The contract talks represent a test case for the U.S.-EU Open Skies agreement in 2010, which allows more European flights into the U.S.

By Jen DiMascio
President Barack Obama entered office pledging to improve the nation's relations with key allies. But with ongoing UAV strikes, revelations of National Security Agency (NSA) surveillance of allies' leaders and continued detentions of terror suspects at the Guantanamo Bay prison, even Obama's supporters concede his image campaign hasn't worked out. “The level of support for the U.S. is back to where it was in the [George W.] Bush administration,” says Rep. Adam Smith (D-Wash.).

Two captions were transposed in an article about engines for the next generation of business jets, in the Oct. 14/21 issue. The bottom image on page 65 shows a Honeywell engine, and a Pratt & Whitney powerplant is shown on page 66.
Business Aviation

By Jen DiMascio
Hundreds of applications for aircraft operations and repair stations are held up, stymied by the FAA's inefficient certification processes, a government watchdog finds. FAA is juggling 1,029 such applications, Jeffrey Guzzetti of the Transportation Department's Inspector General's office, recently told Congress. The situation is so bad, one applicant has been in limbo since August 2006. And it is about to get worse, as requests from NextGen technologies and unmanned aircraft flow into the system.

By William Garvey
Since creating, testing, certifying, producing and promoting an all-new aircraft is such an expensive proposition—I've heard figures ranging from $100 million to 10 times that, depending upon the design's complexity and performance—reworking an existing model is a much-practiced tactic among planemakers. And a new wave of redos is upon us. Indeed, Second Chancers helped anchor the National Business Aviation Association (NBAA) Annual Convention, held in Las Vegas Oct. 22-24.
Business Aviation

By Sean Broderick
The FAA, in a step toward developing a consistent source of regulatory interpretations, is reviewing all guidance and plans to ensure that still-relevant documents are available in an existing electronic database, while duplicative and irrelevant guidance is canceled, the agency’s certification director says.

Lou Seno (Chairman Emeritus )
I really enjoyed you sharing your recent experiences in the venerable HU-16 in “Water Log” (Viewpoint, September 2013). I just returned from Florida where I obtained my multi-engine seaplane rating in the Albatross' “little brother,” the G44 Widgeon. What a blast! Congrats to our friends in Canada on reaching quite a milestone with the PT-6. I have no doubt it will be around for another 50 years yet to come.
Business Aviation

By Jessica A. Salerno, William Garvey
Nextant Aerospace is returning to Beechcraft products to add a second airframe to its remanufacturing business. This time it's targeting the King Air C90. Nextant has teamed with both General Electric and Garmin to offer what it calls the G90XT, a C90 fitted with GE H80 engines in place of the current Pratt & Whitney PT6As and with Garmin's G1000 avionics suite instead of the Rockwell Collins Pro Line 21 platform. While the Cleveland, Ohio, modifier's move to add another Beechcraft aircraft to its product line is not a surprise, the choice of the King Air is.
Business Aviation

By Jessica A. Salerno, William Garvey
Nextant Aerospace is returning to Beechcraft products to add a second airframe to its remanufacturing business. This time it's targeting the King Air C90. Nextant has teamed with both General Electric and Garmin to offer what it calls the G90XT, a C90 fitted with GE H80 engines in place of the current Pratt & Whitney PT6As and with Garmin's G1000 avionics suite instead of the Rockwell Collins Pro Line 21 platform. While the Cleveland, Ohio, modifier's move to add another Beechcraft aircraft to its product line is not a surprise, the choice of the King Air is.
Business Aviation

By Jessica A. Salerno
Luma Technologies has completed development of their latest addition to the Lumatech line of LED annunciator panels for the King Air family and is set to offer a forty-five station variant tailor to the C90A and newer models. Designated the LT-4545, it is a one-for-one drop-in replacement for the existing incandescent annunciators incorporated into the C90 glareshield. Luma Technologies www.lumatech.com
Business Aviation

Richard N. Aarons
The amphibious de Havilland DHC-2 MK 1 Beaver (C-GCZA) departed on wheels from Pitt Meadows Airport, B.C., just east of Vancouver, at 1620 on May 13, 2012, with the pilot and three passengers on board, for a day VFR flight to Okanagan Lake, B.C., some 150 sm to the northeast. It touched down at the lake about 1 hr. and 40 min. later where a single passenger deplaned, as planned.
Business Aviation