Gallery: Products And Services On Display At MRO Europe 2024

FCS Finland #3162 is showcasing its device for cooling jet engines.

Credit: Aviation Week Network

The device, by FCS Finland, for cooling jet engines, can be found at #3162. This cone shaped adaptor is placed over the exhaust pipe of a jet engine and the device sucks hot air from the engine.

Credit: Aviation Week Network

Schaeffler Aerospace exhibits a bearing for the Pratt & Whitney PW4000 engine. Find this and more at #3086.

Credit: Aviation Week Network

Find the IRIS DentCHECK automated dent inspection drone at Donecle's booth #3202B. The drone is designed for non-destructive testing. Developed in collaboration with 8tree, it is a flying dentCHECK for automated detection of dents and bumps.

Credit: Aviation Week Network

Pratt & Whitney exhibited various aircraft parts on the show floor at its booth, #6086. This is part of the geared turbofan engine, which powers various single-aisle commercial aircraft.

Credit: Aviation Week Network

Testia, an Airbus Company, at booth #8051, is exhibiting what it describes as the "Swiss Army Knife of Inspection." It is a multi-purpose tool designed to be used for efficient, flexible and reliable inspections. The Smart UE1 is referenced in more than 185 NTM procedures for maintaining Airbus aircraft.

Credit: Aviation Week Network

SKYSMART MRO brought to the show (booth #8061), a simulator for delegates to take part in a challenge to fly low through a valley in a Boeing Super Hornet F/A -18E fighter jet.

The best score wins a signed copy of the Top Gun Maverick movie poster. 

SKYSMART specializes in automated test equipment, avionics, hydraulics, electrical and instruments and electro-mechanical capabilities.

Credit: Aviation Week Network

Bessel Aeroprop, at #2214, specializes in repair and overhaul of landing gear, propellers and helicopter blades.

Credit: Aviation Week Network

Jordan Airmotive, at booth #3038, displayed the inner workings of a CFM56 -7B. The firm maintains and overhauls CF6-80C2, CFM56-3, CFM56-5B, and CFM56-7B engines. 

Credit: Aviation Week Network

Didsbury Engineering at #9168 showcased these two mechanical and electrical hoists, used to lift aviation components and be used in aircraft hangars for maintenance operations.

Credit: Aviation Week Network

3D.aero, at booth #8084, exhibited its HP-FX Defect Measurement Engine Component Inspection system. It captures and evaluates defects in micrometer scale.

Credit: Aviation Week Network